User Manual
Page 32 of 88
Incoming IP Filtering. Allows you to add, configure, remove Incoming
Filters that will Block specific data traffic to and from the Internet.
To add an Incoming IP filter:
1. Click the Add button.
2. Input the preferred Filter Name.
3. Determine the IP Version that the filter will use.
4. Select the Protocol.
5. Enter the Source’s IP Address, and Source Port.
6. Input the Destination IP Address and Destination Port.
7. Select a WAN Interface/s where the filter will apply.
8. Click Save/Apply button to save changes.
To Next Page
Loading...
Need help?
General
