Easy Start
The MAC Address column shows the device’s MAC address.
The Password column shows the user-supplied Device Password (initially left blank). The
Device Password can be found on the label at the back of the unit. A user may enter the
password by using the Enter Password button (explained below).
To set the Password of the device (required when creating a private network), first select the
device by clicking on it’s name in the lower panel and then click on the Enter Password button.
A dialog box will appear as shown in Figure 1-8 to type the password. The selected device name
is shown above the field for entering the password. Hit OK after entering the new password.
A confirmation box will appear if the password was entered correctly. If a device is not found,
the user will be notified and suggestions to resolve common problems will be presented.
Figure 1-8 : Device Password
Easy Start Page 15 of 20
To Next Page
Loading...
Need help?
General
