Accessories
17
The timer start screen is displayed. Press Start to
start the timer.
Changing the timer ring tone
To modify the timer ring tone, select RING TONE.
Press Valid. .
The list of ring tones appears, the handset plays the
ring tone.
Select the ring tone. Press Volume .
Press or to increase or decrease the volume.
Press Valid. .
Press Return .
Start the timer by pressing Start .
Birthday alarms
You can programme birthday alarms (10 alarms) on
your DECT telephone.
Adding a new birthday alarm
Go to ACCESSORIES / BIRTHDAY / NEW ENTRY.
Enter the name of the person concerned using the
keypad keys. Press Valid. .
Enter the birth date using the keypad keys.
Press Valid. .
Enter the alarm activation time. Press Valid. .
Viewing a birthday alarm
Select the alarm you would like to view, and
press Valid. .
Modifying or deleting a birthday alarm
Select the alarm you wish to edit. Press Option .
The following options are available:
- EDIT: to change the alarm name or date.
- DELETE: to remove a birthday or organiser alarm.
- RING TONE: to set the ring tone that will sound
when the alarm goes off.
- NEW ENTRY: to set up a new birthday alarm.
Monitoring a room
Two handsets are required which must be registered
on the same base to use this function. Use this function
to for example, monitor a room in which a child is
sleeping.
To do so, place one of the handsets in the room to be
monitored. This unit will be in "sender" mode.
The other handset which will remain with you, is in
"receiver" mode.
On the receiver handset:
Go to ACCESSORIES / ROOM MONITOR.
Select the sender handset. Press Call .
The sender handset rings, pick up using the green
key .
On the transmitter handset:
A screen invites you to activate the monitor mode
(sender mode). Press Yes .
Both handsets are now in monitor mode.
• Place the sender handset in the room to be
monitored.
• Keep the receiver handset with you.
To stop monitoring:
-Press Stop on the sender handset. The
receiver set will automatically return to the standby
screen.
-Press Stop on the receiver handset and
confirm by pressing Yes and Stop on the
sender handset at the same time.
The handset in sender mode does not ring
to notify you of incoming calls.
When in monitor mode, the receiver
handset can be used to make calls.
To make a call: press Call and dial the
number.
To answer a call: press green key .
At the end of the call, the handset will
automatically return in monitor mode.
LU Azurite D32T- EN.book Page 17 Mercredi, 9. décembre 2009 2:37 14
To Next Page
Loading...