Azurite D32T - Settings: Base Management and Line Configuration; Handset Registration Mode; Resetting the Base Station

Settings
22
Advanced settings / Base settings
Using a handset to put the base in
registration mode
Go to SETTINGS / ADVANCED SET. / SET BASE /
REGISTR. MODE.
Press Yes to enter the registration mode. The
indicator light on your base starts to quickly blink blue.
Your base will remain in registration mode for about 1
minute.
Resetting the base
When you reset the base, all the base parameters are
reset to their initial values (factory settings).
Go to SETTINGS / ADVANCED SET. / SET BASE /
RESET BASE.
Press Yes .
Enter the base code. Press Valid. .
The RE-INIT. IN PROCESS message is displayed on
the screen.
Deregistering a handset
Go to SETTINGS / ADVANCED SET. / SET BASE /
DELETE HANDSET.
Select the handset you wish to deregister.
Press Valid. .
A screen prompts you to confirm the deregistration.
Press Yes to deregister the handset.
Renaming the base
Go to SETTINGS / ADVANCED SET. / SET BASE /
RENAME BASE.
Select the base for which you want to modify the name.
Press Valid. .
Enter the new name. Press Valid. .
Advanced settings / Line settings
Modifying the network type
Your DECT telephone can be installed on a public or
private network (when using a PABX).
This function enables you to configure your telephone
according to the type of network.
Go to SETTINGS / ADVANCED SET. / SET LINE /
NETWORK TYPE.
A screen presents the current status.
• To keep the status, press Valid. .
• To change the status, press Edit .
The status is modified on the screen, press Valid. .
Modifying the dialling mode
Go to SETTINGS / ADVANCED SET. / SET LINE /
DIAL.
A screen displays the current status.
• To keep the status, press Valid. .
• To modify the status, press Edit .
The status is modified on the screen, press Valid. .
Modifying the flash duration (R key)
If you connect your telephone to a private automatic
branch exchange (PABX) or use it in a foreign country,
you may need to modify the flash duration in order to
use your telephone correctly when using the following
functions: outgoing 2nd call, incoming 2nd call, 3 way
calling.
Contact your service provider to obtain the correct flash
duration and then modify it by doing the following.
Go to SETTINGS / ADVANCED SET. / SET LINE /
FLASHING.
An information screen presents the current flash
duration.
• To keep the duration, press Confirm .
• To modify the duration, press Edit .
Select the new duration using  or .
Press Valid. .
When resetting the base, code is reset to
0000.
The line settings should not providing that
the telephone is connected to the Telkom
network. If the telephone is a PABX phone
then the line settings may require changing.
Contact your PABX administrator if
necessary.
The default dialling mode is tone which is
the method used by all exchanges in the
Republic of South Africa and should not be
changed.
LU Azurite D32T- EN.book Page 22 Mercredi, 9. décembre 2009 2:37 14