Settings
20
Once it is activated, the emergency number will be
automatically dialled when the green key is
pressed from the idle screen.
• To call a number (other than the emergency
number) once the emergency number is active
either use the phonebook or call log functions or
simply dial the number via the keypad and then
press .
Go to SETTINGS / SECURITY / EMERGENCY.
The time and date display is replaced by EMERGENCY
on the idle screen when an emergency number is
programmed and enabled.
An information screen displays the current stored
emergency number and indicates whether it is enabled
or disabled.
• To keep the setting, press Valid. .
• To modify the setting, press Edit .
A list of various executable actions appears:
- ACTIVATE: to activate the emergency number.
- DEACTIVATE: to deactivate the emergency
number.
- CHANGE NO: to modify the emergency number.
To modify the emergency number, select CHANGE
NO. Press Valid. .
Enter the new number using the keypad.
To enter a number from the phonebook, press .
Make your selection and Valid. .
Press Valid. to confirm the number. The mode
changes to active automatically.
Defining the call time limit
You can set your telephone’s operating time.
Once the call time limit is reached, you can no longer
make calls.
To enable calls again, you must either deactivate the
call time limit or set a new limit.
Go to SETTINGS / SECURITY / TIME LIMIT.
An information screen displays the remaining time limit
and its status.
• To keep the setting, press Confirm .
• To modify the setting, press Edit . Enter the
base code (default is 0000). Press Valid. .
A list of various executable actions appears:
- ACTIVATE: To activate the time limit.
- DEACTIVATE: To deactivate the time limit.
- EDIT TIME: To modify the time limit setting.
Select EDIT TIME. Press Valid. .
Enter the new time limit using the keypad (maximum
999 minutes). Press Valid. , the active mode is set
automatically.
Defining barred prefixes - Call barring
You can prohibit the use of certain prefixes on your
telephone. When a prefix is barred, you cannot to call
numbers that begin with this prefix.
Go to SETTINGS / SECURITY / RESTRICTION.
Enter the base code. Press Valid. .
Select an empty location (dashes) or a prefix to modify.
Press Valid. .
Enter the prefix using the keypad. Press Valid. .
Press Return
.
ACTIV.RESTRICTION is displayed.
Press Yes to activate the restriction on that prefix.
Modifying the base (PIN) code
Go to SETTINGS / SECURITY / CHANGE CODE.
Enter the old base code using the keypad (default is
0000). Press Valid. .
Enter the new base code using the keypad.
Press Valid. .
Confirm by entering the new base code again.
Press Valid. .
This function is meant for personal
emergency numbers such as relatives or
carers. Emergency numbers such as
Fire,Ambulance and Police services should
not be programmed.
If the time limit ends during a telephone
conversation, communication will not be cut
off. Once you have hung up, it will not be
possible to make a new call.
Calls between handsets (internal calls) are
not affected by the call time limit.
Depending on the programmed prefixes,
certain numbers will no longer be
accessible. For example, if you
programmed 06 as a barred prefix, it will not
be possible to call a number that begins
with 06.
LU Azurite D32T- EN.book Page 20 Mercredi, 9. décembre 2009 2:37 14
To Next Page
Loading...