B.M.P. DYNAMICROLL - INSTALLATION GUIDE; INSTALLATION INSTRUCTIONS; REQUIRED EQUIPMENT

To Next Page

To Previous Page

Operating instructions

Use and maintenance manual

INSTALLATION INSTRUCTION

- Alwaysuseapowercircuitspecificallydedicatedtothedoor.Forwiringfollowthemanufacturer's

instructions.

- Tightenthescrewsoftheelectricalterminalstopreventloosening.

- Makesurethepowersourcehastherequiredcapacity.

- Makesurethethicknessofthecableconformstowhatis

statedinthespecificationofthepower

source.

- Neverinstalladifferentialcircuitbreakerinwetordampareas.

EQUIPMENT NEEDED

1 Flexometer 10 Level

2 Suitable lifting equipment (stairs

elevator, ecc.)

11 Set of allen keys (17 mm, 13 mm,

10mm, 8 mm)

3 Screwdriver set 12 Tester

4 Iron drill 13 Hammer

5 Hammer drill 14 Cordless screwdriver

6 Drill bits (iron and concrete) 15 Grinder

7 Scissors 16 Silicone gun

8 Stripping cable 17 Pliers

9 Vices

Elevator Forklift

INSTALLATION