Spray-gun cleaner Starter Page 9
equipment and facility engineering
4. Safety regulations
The B-TEC GmbH machines are operationally safe and are constructed according to the state of the
art. Due to the nature of the processes there are processes and parts that cannot be protected
without impairing operability and functionality. Improper use of the gun-cleaner can be endanger the
health of operator and of other and cause damage to the cleaner itself or to other materials and
assets. B-TEC GmbH is not liable for any damages resulting from improper or incorrect use.
4.1 Instructions, rules and information of the employers’ liability insurance association
The following occupational safety regulations (BGV), rules (BGR), and information (BGI)
have to be followed while using spray guns and part cleaning systems:
"Principles and prevention", general rules
"Safety and health protection warnings at the workplace"
"Safety rules for air pollution control systems for the workplace"
"Security by operating instructions"
" Avoidance of ignition from electrostatic charges"
" Guidelines for facilities for cleaning parts with solvents"
" Use of protective clothing"
"Use of eye and face protection"
"Use of protective gloves"
" Ordinance on Industrial Safety"
The source documents (with exception of the " Ordinance on Industrial Safety") can be obtained
from: Carl Heymann Verlag KG, Luxemburger Str. 449, D-50939 Köln, Germany.
The manufacturer is not liable for damages caused by changes of the cleaner that have
not been specifically authorized by the manufacturer. The removal or alteration of safety
devices immediately voids the warranty and is an infringement of European safety
standards.
Read and follow this Instruction manual and the safety instructions carefully before
commissioning!
To Next Page
Loading...