Spray-gun cleaner Starter Page 17
equipment and facility engineering
7. Care and maintenance
7.1 Maintenance of the machine
We recommend cleaning the stainless steel filter on the intake hose regularly (at least every
time the cleaner is changed.) → if the filter is defective, it must be replaced immediately.
Defective filters either have heavy paint buildup, causing clogging of the filter surface, or, the
filter has a breach that allows contaminated solvent to be drawn in by the pump, which can
damage the pump or clog the washing nozzle.
Clean the perforated stainless steel grille and the interior walls of the machine regularly.
Clean any residue out of the drain pan, in order to ensure reliable drainage of the cleaning
agent and solvent and to ensure that there is permanent sufficient flow capacity in the drain.
When the machines will not operated for a longer period of time (for example during
vacations) a clear rinse should be used after the final cleaning cycle so that the jets will not
be clogged with heavily contaminated solvent.
The operating permission will expire, if other than original B-TEC replacement parts are used.
Customer service: Contact your dealer, or directly:
7.2 Disposal
If the machine shall be disposed of, please contact B-TEC or your dealer and request an
appropriate quotation or the requirements for proper disposal.
The machine must not be disposed of as standard household waste. Depending on the level
of contamination, it has to be handled as hazardous waste. Consult your local authorities as
needed.
The machine hast to be disconnected from the compressed air supply before any repair
work!
B-TEC GmbH
Zunftweg 6-8
D-31303 Burgdorf / Ehlershausen
Tel.: ++49(0)5085-97100-0
Fax: ++49(0)5085-97100-30
Email.: b-tec@t-online.de
www.btecsystems.de
To Next Page
Loading...
Need help?
General