Spray-gun cleaner Starter Page 2
equipment and facility engineering
The B-TEC devices and machines are only allowed to be used for the purpose explicitly described
below. Any other use is in contrast with the regulations. The manufacturer cannot be held liable for
damages resulting from such non-regulations use.
The B-TEC devices and machines are only to be used for the purpose explicitly
described below!
These devices and machines are allowed to be used for cleaning varnish and spray paint guns as well
as paint soiled parts and hand tools using solvents (A I, A II, A III) or non-combustible, aqueous
cleaners for water-based varnishes. Exception: share of Aceton > 65 %.
The cleaners are not allowed to be used in continuous operation as for instance in serial production.
Improper use of the washers can endanger the health of the operator and of others and cause
damage to the cleaner itself or to other materials and assets.
Improper use of the cleaners can endanger the health of the operator!
1.1 Explanation of the symbols
You will find this symbol whenever attention is drawn to situations in which danger to
life can arise due to or during incorrect or improper operation. Pay special attention to
these symbols and act carefully.
You will find this symbol in the operating manual whenever your attention shall be
drawn to correct work procedures, economic ways of operation or when the machines
can be damaged by incorrect operation.
To Next Page
Loading...
Need help?
General