B2 Audio RAGE SERIES - Design Features and Specifications; RAGE Series Technical Specifications; Continuous Output Power Ratings

Design features
Circuit Configuration: HI-EF Class D Hi-ef Class D fr hi-ef Class D fr
Frequency Response: 15 ~ 200 Hz 10 Hz ~ 25 Khz 10 Hz ~ 27 khz
Signal to Noise Ratio: > 85 dB > 90 db > 90 db
Input Sensitivity: 4 V ~ 0.1 V 6 v ~ 0.2 v 6 v ~ 0.2 v
Crossover Circuit:
high pass crossover: 50 hz - 5 Khz (ch 1~4) 20 Hz - 5 khz
high pass crossover : 20 ~ 200 hz (ch 5-6)
24 dB / Oct 24 db / oct 24 db / oct
Low Pass Crossover:
band pass crossover: 20 ~250 hz (ch 5~6) 50 hz ~ 5 khz
20 ~ 200 Hz 50hz~5khz (ch 1-4)/20 - 200hz (ch 5~6) 50 hz ~ 5 khz
Subsonic Crossover: 10 ~50 Hz
Damping Factor: > 300 > 250 > 250
Bass Boost Frequency: 45 Hz
Remote Control w/clip & low volt: Included
Power Terminal Gauge: 0 GA 4 ga 4 ga
Fuse Rating: 250 A 120 a 60 a
Dimensions: 45 x 18.5 x 5.4 cm 35 x 14.2 x 4.9 cm 23 x 14.2 x 4.9 cm
17.7 x 7.3 x 2.1” 13.7 x 5.6 x 1.9” 9 x 5.6 x 1.9”
Continious output power (RMS)
rage 2500.1 rage 1200.6 bridge @ 4 ohm rage 600.4 bridge @ 4 ohm
4 ohm 750w (Ch 1-4) 110w x 4 / (ch 5-6) 200w x 2 (Ch 1-4) 320w x 2 / (ch 5-6) 640w x 1 100w x 4 300w x 2
2 ohm 1500w (ch 1-4) 160w x 4 / (ch 5-6) 320w x 2 NA NA 150w x 4 NA
1 ohm 2500w Na Na
Description of specifications
* Speaker overload
* Short circuit
* Input Voltage - RCA & Power Supply
3
Operational voltage 9V ~16V.
rage 2500.1 rage 1200.6 rage600.4