Need help?Do you have a question about the B2 Audio RAGE SERIES and is the answer not in the manual?
Lists RMS power output for RAGE 2500.1, 1200.6, and 600.4 at different impedances and bridge modes.
Provides essential steps and warnings for safe and correct amplifier installation to avoid damage.
Details proper ground connection to chassis and +12V power connection to the battery, including cable size.
Sets the master amplifier to 'OUTPUT MASTER' for linking with another amplifier.
Lists checks for voltage, remote connection, ground, and protection LED when the amplifier doesn't power on.
Explains causes like shorts, overload, or voltage issues when the protection LED is active.
Addresses issues related to blown fuses and amplifier overheating due to impedance or airflow.
Covers insufficient/distorted audio, turn-on thump, and high-hiss/engine noise in speakers.
General| Channels | 1 |
|---|---|
| Class | D |
| Input Sensitivity | 6V - 0.2V |
| Subsonic Filter | 10 Hz - 50 Hz |
| Operating Voltage | 9V - 16V |
| Bass Boost | 0dB - 12dB |
| Phase Shift | 0° - 180° |
To Next Page
