B2 Audio Zero Five The Falcon - Panel Layout; Bass Boost

4
Panel layout
The Falcon / The Osprey
INPUT bass boost
RCA signal input for left & right channel. Level control of 0~9 dB @ 45 Hz.
A minimum of 0.2V input signal is required for correct
operation. Using only 1 input will minimize input signal
Remote level control port
and amplier will need to be gained as such. Connection of external signal level control with clip
indicator. Caution, it is not a volume knob and shall be
POWER & PROTECTION INDICATOR adjusted in accordance with the ampliers gain.
Power LED, blue light shows correct operation,
Protect LED, red light shows general malfunction, faulty LPF (LOW PASS FILTER 20 Hz ~200 Hz, 24 dB/oct)
connection or thermal protection. Adjusts the cut o point for the low pass crossover
at the frequency chosen.
clip INDICATOR
The LED will light up if signal is clipped. An occastional Phase
ashing light is acceptable, a constant lit diode is not. Variable phase adjustment from 0 ~ 180
master / slave / slave 2
GAIN (5V~0.2v)
Master & slave settings enables strapping of the amplier
Adjusts signal input voltage from the input source with another identical amplier to achieve twice the power.
to match the ampliers input stage. When set in master, this unit will be sending the
0.2 V ~ 5 V is the operational voltage. signal to the slave unit, that will have the switch set to
Voltages beyond may cause errors or damage to the input slave with the rca connected to the input.
input section. Slave 2 setting will work as a daisy chain of subsequent
ampliers. Here each amplier will work independently,
SUBSONIC but the signal input will be taken from the master amplier’s
Variable subsonic setting from 10 Hz to 50 Hz. output making gain matching easier.
It is highly recommended to set it according to the tuning
of your subwoofer enclosure to avoid unnecessary strain to
Gain slave 2
your sound system. In daisy chain mode or by gain matching, voltage could
eventually dier a few tenths. The slave 2 gain provides
ne tuning of the gain signal from the master amp’s output.
avd
Connection for external voltage display showing the true
input voltage for the amplier.
o