Need help?Do you have a question about the Baby Lock BL-5180 and is the answer not in the manual?
General| Brand | Baby Lock |
|---|---|
| Model | BL-5180 |
| Category | Sewing Machine |
| Language | English |
Instructions for detaching the light cover.
Steps to remove the machine's front face plate.
Procedure for removing the belt cover.
Steps to detach the machine's base.
Adjusting the vertical height and alignment of the needle bar.
Setting the correct position for the needle guard.
Aligning eccentric cams for needle bar, lower looper, and slide block.
Setting the position of the feed rock eccentric cam.
Adjusting the upper looper rod eccentric cam.
Setting the radius of the lower looper.
Adjusting the timing of the lower looper's movement.
Ensuring proper gap between the lower looper and needle.
Setting the returning position of the upper looper.
Adjusting the timing of the upper looper's operation.
Adjusting the needle thread take-up lever.
Setting the upper looper thread take-up lever.
Adjusting the lower looper thread take-up lever.
Setting the correct height for the main feed dog.
Setting the correct height for the sub feed dog.
Adjusting the front-to-back position of feed dogs.
Synchronizing the feed dog movement with other parts.
Setting the desired stitch length.
Adjusting the differential feed mechanism.
Setting the correct angle for the upper knife.
Adjusting the vertical position of the upper knife.
Checking for play in the upper knife arm mechanism.
Adjusting the presser foot's height and alignment.
Setting the correct tension for the motor drive belt.
Checking and adjusting play between the hand wheel and frame.
Positioning the balance weight on the hand wheel shaft.
Adjusting the lower looper balance weight.
Setting needle height for different models.
Adjusting the presser foot height.
Procedure for replacing the chaining tongue.
Steps for replacing the upper knife.
Steps for replacing the lower knife.
Aligning needles after installing a new needle plate.
Adjusting the needle thread sensor cable for timing.
Adjusting the looper thread sensor cable for timing.
Checklist for resolving jet-air threading problems.
Diagnosing issues with the jet-air pump and pipe connections.
Guide for adjusting jet-air threading system components.
Steps to replace looper driving cams and rollers.
Specific measurement points for different machine models.
To Next Page