Frame Center Position (Embroidery Unit)
Standard： In the test mode #23, when pressing , the needle
drops in the center of embroidery sheet hole.
1. Remove the presser foot.
2. Turn off the machine, then attach the embroidery unit.
3. Attach the extra large embroidery frame.
*Size: LL,300x180mm (12inch x7inch)
4. Put the embroidery sheet on the frame.
5. Go to the test mode #23.
6. Press , and check the needle drop position.
Needle should
be at the center.
1 of 2
To Next Page
Loading...
