Frame Center Position (Embroidery unit)
Standard： In the test mode #23, when pressing , the needle
drops in the center of embroidery sheet hole.
In case the needle does not drop in the center of embroidery sheet hole,
1. Go to the test mode #42.
2. Turn the pulley until the needle bar comes
to its highest position.
3. Press the buttons on the screen to adjust the
needle drop position.
4. After this adjustment, turn off the machine.
* The offset value is memorized in the machine
automatically.
2 of 2
Needle should
be at the center.
To Next Page
Loading...
