Baby Lock BLTA Altair - Guide Line Position; Guide Line Parallelism and Center Alignment

Parallel
Standard：Guide line is parallel to the feed dog hole of needle plate. Match the
center position of guide line with the center needle position.
1. Remove the presser foot.
2. Go to the test mode #27.
3. Press (#1).
4. Press (#2). The guide line moves to the left.
5. Check that the guide line is parallel to the feed dog hole.
In case not parallel,
5-1．Remove the face plate assy.
5-2．Move the notch (#3) of laser module to adjust the guide line
parallelism.
1 of 2
#3
Laser module
#1
#2
Guide Line Position
63