Smoke Box Switch
There is one switch behind the smoke box door (Figure 16) that controls the operation of
the smoke generator. This switch has two positions: ON and OFF. In the ON position,
the function above is controlled by the device installed in the plug-and-play socket. In
the OFF position, the function will remain off, no matter how power is supplied to the
locomotive.
Control Switches in the Tender
To access the tender control switches, remove the coal load by lifting it from the front
of the tender (Figure 17). There are four electrical control switches mounted at the front
of the main PC board in the tender. The following descriptions of the locations are by
looking at the tender from the rear (Figure 18).
1.
16
18
17
To Next Page
Loading...
