out of the way. Next, remove the three screws holding the coupler shaft to the tender. Replace the low-height coupler
and shaft with the high-height coupler and shaft (with the trip pin pointed down toward the truck) and reinstall the three
screws (Figure 15). Note: when re-installing the coupler shaft, be sure to reinstall the coupler shaft centering spring. Once
the desired coupler is in place and working, reinstall the rear truck of the tender.
ELECTRONICS
Your 4-6-0 locomotive features totally isolated electronics, which allow for easy installation of the control system of your
choice (see your hobby retailer). Switches are found in two locations: in the smoke box behind the smoke box door and in
the tender underneath the coal load.
14
15
To Next Page
Loading...
