Backyard Creations 2595217 - How to Use Your Fire Pit; Remove Deflector Ring; Position Fire Pit on Stand; Add Fuel and Light Fire

SMOKELESS FIRE PIT BUNDLE
Instruction & User Manual
HOW TO USE YOUR FIRE PIT
Remove the deector ring from the
dual wall re pit.
Place fuel in the center of re pit. Start
with small kindling twigs or re starters.
CORRECT INCORRECT
DO NOT EXTEND ABOVE OR COVER AIR
HOLES AT THE TOP OF FIRE PIT WITH WOOD.
Use rewood, cardboard, charcoal, or
hardwood to fuel re. Hardwood is best for a
long burn.
Make sure the deector ring edges
are pointed upwards to enlarge the
appearance of the re.
Light your re starters and reafx the deector ring
back on top of the re pit in the correct position.
CORRECT INCORRECT
6
Once cooled, turn re pit over to clean out ash and residue.
For a deep clean, wipe down re pit with a soft cloth.
Take the re pit stand and place it on an even surface.
Center the re pit on top of the stand.
When done, let re burn out on its
own. Do not extinguish re with water.
CAUTION: RISK OF INJURY TO THE USER AS
WELL AS DAMAGE TO FIRE PIT COULD OCCUR
IF WATER IS USED TO EXTINGUISH FIRE.
CAUTION: HOLES ON
FIRE PIT STAND HAVE
SHARP EDGES. DO
NOT PUT FINGERS IN
THE HOLES.
DO NOT USE SCOURING PADS
TO CLEAN FIRE PIT.
CAUTION: DO NOT TOUCH
COALS OR ASH UNTIL
COMPLETELY EXTINGUISHED
AND COOL.