Backyard Creations FC-30-MN - Hardware Parts List; Tools and Materials

SKU 272-0095/FC-30-MN
04
LARGE PARTS (NOT TO SCALE)
© 2018 Jack-Post Corporation 09/18
TOOLS AND MATERIALS
TO ASSEMBLE • Hammer • Screwdriver TO FINISH UNTREATED LUMBER
• Lumber – See Buying Guide • 7/16" wrench or adjustable wrench or pliers • Sandpaper
• 1 lb. GALVANIZED 8 penny nails • Drill, 1/4" bit and 5/8" bit • Brush
• White Glue • Saw (or use pre-cut lumber) • Varnish, stain or paint
LUMBER BUYING GUIDE
1. Determine how long you would like your picnic table. Banquet or longer tables may be built with two picnic table hardware kits.
2. Select MATERIAL PLAN for table top and benches. Generally, the 2 x 4 plan will be the least expensive. The 2 x 10 plan is easiest to build.
3. Purchase lumber or the cut sizes shown below.
NOTE: Pressure-treated lumber is not necessary for picnic tables. The new ACQ pressure-treated lumber is corrosive and will cause premature rusting of
conventionally plated nuts and bolts.
The threaded fasteners included with this product have been specially coated to help resist the corrosive eect of the ACQ treatment.
BRACKET (2)
BRACE (2)
LEG (4)
HARDWARE PARTS LIST (SHOWN TO SCALE)
HEX NUT (30)
2" • 50mm CARRIAGE BOLT (14)
3-1/4" • 82mm CARRIAGE BOLT (8)
2-5/8" • 67mm SLOTTED HEAD SCREW (4)
2" • 53mm SLOTTED HEAD SCREW (4)