Why does the emitter glow unevenly on my Backyard Pro Patio Patio Heater?
If the emitter on your Backyard Pro Patio Heater glows unevenly, it could be due to a blockage in the burner injector. Try cleaning or replacing the burner injector. Another cause could be that the base is not on a level surface, so place the heater on a level surface. Finally, low gas pressure could be the issue, so replace the cylinder with a new one.
Why is the ignition delayed on my Backyard Pro Patio?
If the ignition of your Backyard Pro Patio Heater is delayed, it could be due to clogged main burner carryover ports. Try cleaning the main burner ports. Another possible cause is low gas pressure, so you may need to contact your gas supplier.
Why does Backyard Pro Patio make a whistling noise?
If your Backyard Pro Patio Heater is producing a whistling noise when the burner is lit, it could be because air passageways are blocked. Check the minimum installation clearances and air passageways for any debris. Another possibility is air in the gas line. Operate the burner until the air is completely purged.
What to do if Backyard Pro Patio Heater burner flame goes off immediately?
If the burner flame goes off immediately after ignition on your Backyard Pro Patio Heater, it's likely due to low gas pressure. Contact your gas supplier to check the gas pressure.
Why is the burner flame low on my Backyard Pro Patio?
If the burner flame on your Backyard Pro Patio Heater is low, first check if the supply hose is bent or twisted. If it is, straighten the hose and perform a leak test. Also, a blockage in the burner injector could be the culprit. Try cleaning or replacing the burner injector.
Why does my Backyard Pro Patio smell like gas?
If you notice a gas odor during combustion with your Backyard Pro Patio Heater, it could be due to several reasons. There might be foreign matter in the gas or on the burner ports, so check the gas passageway and burner. Alternatively, the heater could be burning vapors from paint or impurities in the air; in this case, stop storing and using odor-causing products near the heater. Finally, there could be gas leaking from the regulator and hose connections, the valve and pipe connections, and the pipes. Locate and correct any leaks, or contact your gas supplier for assistance.
How to fix Backyard Pro Patio Patio Heater that will not light?
If your Backyard Pro Patio Heater burner won't light, the burner injector might be clogged. Try cleaning the burner injector. Another possible cause is low gas supply pressure, in which case you should call your gas supplier.
Crucial warnings about immediate hazards, fire, explosion, burn, asphyxiation, and carbon monoxide poisoning.
Details hazards from combustibles, volatile materials, propane storage, and high temperatures.
Explains CO poisoning risks from combustion and the need for ventilation.
Warns about hot surfaces, unattended use, and safe servicing practices.
Attaching wheels and stability ring to the base of the heater.
Connecting lower and upper supports to the base and middle plate.
Installing the control box with battery and attaching the reflector to the damper.
Installing the glass tube with rubber ring and attaching wire guards.
Securing side panels and attaching the front panel with the control knob.
Connecting the propane hose to the control box and the regulator to the cylinder.
Details on cylinder type, condition, storage, and connection safety.
Step-by-step guide to check for gas leaks using soapy water solution.
Verifying outdoor use, ventilation, gas connections, and pilot ignition.
Adjusting heat settings, turning off, and regular cleaning of exterior and air passages.
Instructions for storing the heater between uses and after extended periods.
General| Type | Propane |
|---|---|
| Wheels Included | Yes |
| BTU | 48, 000 BTU |
| Material | Steel |
| Tank Capacity | 20 lbs |
| Warranty | 1-Year Limited |
To Next Page