5
-
3
DAILY INSPECTION BEFORE
STARTING
1. Check the engine oil level.
After wiping out the dipstick, insert
it fully and then withdraw it. Oil
should be between the two marks
on dipstick.
Do not operate the engine if oil
level is below minimum mark. If
below, add the corresponding
grade oil according to the season
through the ller.
2. Feed grease to all greasing points
indicated below every 10 hours
when working in damp and muddy
conditions.
Front axle pin
Steering shaft and Cylinder end
Tie rod both ends
Front axle supporter
3. After cleaning the machine with
highly pressurized water, lubricate
the indicated points with grease
below if necessary.
Bonnet latch
Seat sliding rail
PRE-OPERATION CHECK
•
Do not provide illumination
with a lit cigarette or a lighter
when fueling.
•
Never fill the fuel tank while
the engine is running or hot.
•
After lling the fuel tank, close
the fuel filler cap complete-
ly and wipe o the excess fuel
thoroughly.
•
If the fuel hoses are damaged,
fuel will leak. Make sure that
you check for any leakage.
DANGER
•
Perform the maintenance on a
at and safe location that will
keep the tractor in place and
will not cause a risk to peo-
ple passing by. Before carry-
ing out the maintenance, place
blocks at the front tires to pre-
vent movement.
[Otherwise]
An unexpected accident may oc-
cur, such as overturning of the
tractor.
•
When going under the imple-
ment, fully close the slow/stop
valve.
[Otherwise]
There is a risk of injury due to
implement falling.
WARNING
2024h_3026h.indb 32024h_3026h.indb 3 2020-09-18 오후 6:17:222020-09-18 오후 6:17:22
To Next Page
Loading...
