Bad Boy 3026H 2021 - Cold Start; Stopping Engine

5
-
14
BAD BOY TRACTOR
COLD START
1. When starting in cold weather, turn
the ignition switch to the "ON" po-
sition and then wait until the pre-
heat indicator is turned o󰀨.
2. For safe operation, turn the igni-
tion switch to the "START" position
with the clutch pedal depressed.
3. Repeat the above procedures until
the engine is operated smoothly.
4. Let the engine idle at 1,200 rpm to
warm up the engine up to the op-
erating temperature.
CAUTION
•
In case of the tractor equipped
with the cold start system, do
not use starting uid.
1. Put the acceleration lever on LOW,
and turn the main switch to “OFF”.
2. Put shuttle lever, main gearshift
lever and PTO shift lever to “N”.
put PTO ON/OFF switch in to the
“OFF” position and 4WD lever po-
sition on disengage.
3. Put the hitch control lever on
“DOWN”
STOPPING ENGINE
•
When stopping the engine,
never stop it with the reducer
lever.
•
After stopping the engine,
make sure to apply the park-
ing brake.
CAUTION
•
For warming-up operation,
strongly step on the brake
pedal and pull your parking
brake.
NOTE
•
When leaving the tractor, park
the tractor in a flat and safe
place, put the shuttle lever
and the main shift lever to “N”,
and block the tires.
[Otherwise]
The tractor may move and cause
an accident. Always set the park-
ing brake.
WARNING
(1) Hand Throttle Lever
: Faster Engine RPM (A)
: Slower Engine RPM (B)
2024h_3026h.indb 142024h_3026h.indb 14 2020-09-18 오후 6:17:252020-09-18 오후 6:17:25