PAGE 24
SECTION 4: ELECTRICAL SYSTEM
This mower is equipped with multiple protective fuses.
Ensure all fuses are clean and well connected.
A blown fuse usually indicates a problem within the
electrical system or an electrical component. Ensure the
battery terminals are tightly fastened. Never replace a
fuse with one of a higher amperage rating or ‘bypass’ a
fuse in any way. Doing so creates a significant fire hazard
and can cause severe damage to the mowers electrical
components. If a fuse is repeatedly blowing, contact your
Bad Boy dealer.
Check the condition and connection of the relays. Ensure
that they are clean and connected. Make sure that wire
terminal ends have not been pushed out of the relay
block.
On most models, the red wire coming out of the engine is
the charging wire from the alternator. Check for 13.6 -
14.2 volts dc at this wire with engine at full throttle.
If you are having issues starting your mower ensure the
signal wire is connected to your starter solenoid.
Breaker
To Next Page
Loading...
Need help?
General
