57
DRIVE CHAIN CLEANING, OILING AND ADJUSTING
Clean and oil the chain as the following:
1. Wash the chain with water.
2. Dry the chain, and then oil the links with Chain lube or equivalent.
Adjusting the Drive Chain
The drive chain should be adjusted making sure there is 20~30 mm (0.8~1.2
inches) of slack, as shown above.
WARNING
Failing to inspect the drive chain slack before each use of the ATV could
be hazardous.
Too much chain slack could cause the chain to come off the sprockets,
resulting in an accident or serious damage to the ATV.
Inspect the drive chain slack before each use.
20~30 mm
(0.8~1.2 inches)
1. Loosen bolts
2. Adjust chain tension by using a crescent wrench turning axle as-
sembly housing (2) .
3. When proper slack is obtained tighten nuts
1
(1)
(1)
INSPECTION AND MAINTENANCE
2
To Next Page
Loading...