Baker Ruskinn Concept-M User Manual

Affix Serial Number Sticker Here
User Manual UM-039
Concept-M
Anaerobic and Microaerophilic
Workstation
Concept-M 400 / Concept-M 500

Baker Ruskinn Concept-M Specifications

General

Oxygen Control	Yes
Temperature Control	Yes
Material	Stainless steel
Humidity Control	Yes
Power Supply	230V, 50/60Hz
Power Consumption	400W
Lighting	LED
Gas Control	O2, CO2, N2
CO2 Control Range	0% to 20%
Temperature Control Range	Ambient +5°C to 45°C
Humidity Control Range	Up to 85% RH

Summary

SAFETY INSTRUCTIONS

CAUTION: Asphyxiation Risk

Warning about operating the unit in small enclosures due to gas release.

REGULATORY COMPLIANCE

North American Region

Precautions

Testing and approval to EN61010 standards and potential EM interference.

SERVICE REQUIREMENTS

Electrical Supply Requirements

Gas Supply Requirements

USING THE WORKSTATION

Using the interlock

Operating the interlock outer door

Operating the interlock inner door

Transferring material into the workstation chamber via the interlock

Removing material from the workstation chamber via the interlock

Hand access to the main chamber

Vacuum Operation

Workstation Entry

Workstation Exit

Humidity Control

Initial Settings Screen

Environment Control

Oxygen Sensor Calibration

Warnings

Temperature Alarm

Set-Point Failure Alarm Screen

Input Gas Pressure Alarm

CLEANING AND SERVICE REQUIREMENTS

Service and Cleaning Overview

Cleaning procedure – during and after each use

Cleaning procedure – deep clean with front screens removed

Cleaning

Reinstalling workstation components

1 Year Service

TROUBLESHOOTING

The Workstation will not Switch on

Checks to perform if the workstation fails to power on.

The Circuit Breaker Trips

Steps to diagnose and resolve circuit breaker tripping issues.

Low Gas Pressure

Identifies causes and solutions for low gas pressure alarms.

Excessive Gas Usage

Internal Equipment not powering up

The Workstation is only partially operational

WARRANTY INFORMATION