20906 Higgins Court, * Torrance, CA 90501 * Tel. (310) 533-3939
6. INSPECTION AND MAINTENANCE
6.1. INSPECTION
Visual inspection should be carried out on a daily basis of:
• Operation of the machine.
• Defects to hoses and hose connection.
• Damage to the power cord.
6.2. MAINTENANCE
Clean regularly the exterior of the Jelly Quick
• WHEN USING WATER HOSE DO NOT DIRECT TOWARDS SEALS
AND OPERATING PANEL.
• DO NOT USE HIGH-PRESSURE SPRAYERS
• DO NOT USE STEAM CLEANERS.
After a maximum of 40 operating hours the following cleaning procedures must be
carried out:
- Rinse out the pipe system.
Rinsing out pipe system
- Fill a bucket with warm water at a maximum of 40°C/ 100F.
- Remove nozzle from spray gun
- Place suction hose with quick coupling and valve cap in the bucket.
- Spray water completely until bucket is empty.
Page 10
To Next Page
Loading...