The standard I/O modules must now be configured appropriately for the configuration of the
header module.
If necessary, these can be taken over into the configuration table from the hardware catalog
by means of drag & drop.
Module addressing:
Double-clicking on the addressable modules allows you to change the addressing in the
"Addresses" window
Configuring a standard input / output:
If one of the possible port pins (pin 4) is to be configured with a standard function (input,
output), the "Standard I/O" placeholder module must be used for the corresponding slot.
To address the inputs and outputs, input pin 2 / 4 and output 2 / 4 must be taken over from
the catalog and used in the configuration according to the given modules.
With the remaining modules, the various functions are mapped into the process data areas.
To Next Page
Loading...