Balluff BNI PNT-104-105-Z015 - Bit Mapping and Function; Inputs Pin 4; Outputs Pin 4

www.balluff.com
16
5 Integration
Inputs pin 4
Inputs pin 2
Outputs pin 4
Outputs pin 2
Signal from configured inputs or outputs are depicted in the modules
Inputs pin 4 / Inputs pin 2 and Outputs pin 4, Outputs pin 2.
The "Inputs pin 2" module also depicts the diagnostic inputs of the diagnostic input
function.
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Port 7
Port 6
Port 5
Port 4
Port 3
Port 2
Port 1
Port 0
Actuator shutdown
pin 4 / pin 2
Depicts a short circuit between a set output to ground at the respective port pin.
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Port 7
Port 6
Port 5
Port 4
Port 3
Port 2
Port 1
Port 0
Actuator warning
pin 4 / pin 2
Feedback if a voltage is being supplied at an output that is not set.
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Port 7
Port 6
Port 5
Port 4
Port 3
Port 2
Port 1
Port 0
Restart pin 4 / pin 2
If this function is configured, after an actuator short-circuit there is no automatic restart,
but rather the port must be activated by inserting the corresponding bit.
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Port 7
Port 6
Port 5
Port 4
Port 3
Port 2
Port 1
Port 0
5.3. Bit mapping and
function
Bit mapping and function of the configurable modules