Bamix MX1020003 - Cleaning and Care; What to Do

50
Always unplug the appliance
The bamix
®
is very easy to clean. Remove the attachment and
wash it separately. To clean the attachment, rinse the dirty parts
under running water (do not switch on the appliance).The ea-
siest way to clean off bits of food which have stuck to the ba-
mix
®
is to hold it in a jug with hot water and switch it on. Take
care that the switch of the bamix
®
does not come into contact
with the water.
Important: Clean the appliance as soon as you have finished
working, to prevent the drive shaft or the attachment get-
ting clogged. If not in use, always remove the attachments
from the appliance.
To keep the bamix
®
running smoothly for longer, lubricate it eve-
ry few months with vegetable oil.
Hold the bamix
®
with the cutter guard facing up, lubricate the
drive shaft with 2-3 drops of oil and then run the appliance for
approx. 30 seconds. Then clean the shaft with hot water.
What to do …
If the drive shaft of the appliance fails to rotate?
If the bamix
®
is not used for a prolonged period of time, the
drive shaft might become stuck, or the attachment might slip
from the shaft stub, as the parts are clogged up by minute food
residue. Place the attachment for 5-10 minutes in a jug of hot or
boiling water. Then switch on the appliance. Normally, all parts
should now work perfectly again. If not, try to free the shaft
carefully with pliers.
The appliance and the cutter guard are not suitable
for cleaning in the dishwasher. If the appliance is
left in water too long, the cutter guard could beco-
me corroded (black discolouration).
Cleaning and care