Bantam e-STATION 902 - Save Data Program

Display
Save [00] NiMH
14.4V 3000mAh
Display
NiMH Charge Mn*
Current 3.0A
Setting up charge current.
Save Data program
'> 3 seconds'
voltage
data
number
capacity
Display
+-
Display
NiMH Discharge *
4.0A 11.0V
Setting up discharge current and final voltage.
+-+-
Display
NiMH Cycle *
CHG>DSCH 3
+-
+-
902 has a data storage and load program for your convenience. This feature can store up to 10
battery data by number that represent the individual specification of batteries you are using. They
can be called back for the process of charging or discharging without setting up the program again.
To set up the parameter value in the program, press key to make it blink then change the
value with or key. The value will be stored by pressing key once.
The parameter value setting up in this screen does not
affect charge or discharge process. They only represent
the specification of the battery. The following screens
will automatically be displayed exactly matched with the
battery type you set up. The example shows the battery
pack of NiMH, 12 cells and 3000mAh of capacity.
The voltage ranges from 0.1 to 33.6V and the capacity
ranges from 10 to 9990mAh.
Display
Save . . .
Saving the data.
Setting up the sequence of charge and discharge, and
the cycling number.
'> 3 seconds'
DEC
◀
INC
▶
DEC
◀
INC
▶
DEC
◀
INC
▶
DEC
◀
INC
▶
DEC
◀
INC
▶
Start/
Enter
Start/
Enter
Batt type
Stop
Program Select
Save/Load
DEC
◀
INC
▶
DEC
◀
INC
▶
type of battery
Start
Enter
DEC
◀
INC
▶
Start
Enter
- 15 -