To Next PageTo Next Page
Need help?Do you have a question about the Bantam e-STATION BC6 and is the answer not in the manual?
Describes the AUTO function for automatic current setting and error prevention.
Explains the AC/DC input capability and power specifications for charging.
Highlights the built-in balancer for Lithium batteries, eliminating external need.
Details the monitoring and balancing of Lithium battery cells during discharge.
Lists Li-Ion, LiPo, and LiFe batteries supported by the charger.
Explains special charging modes for Lithium batteries to reduce time or prepare for storage.
Covers safety features like delta-peak sensitivity and auto-charge current limits.
Identifies and describes the physical ports, screen, and buttons of the charger.
Essential warnings regarding environment, power, and handling to prevent damage or fire.
Details voltage levels, current limits, and cutoff for various battery types.
Guides on preventing short-circuits, connecting leads, and handling incompatible batteries.
Provides advice on charge quantity calculation, connection, and avoiding deep discharge.
Guides on selecting Lithium voltage type and verifying cell counts.
Covers delta-peak sensitivity for NiMH/NiCd and temperature cut-off settings.
Describes assigning the 3-pin port for USB or temperature and enabling PC link.
Covers waste time, safety timers, capacity cut-off, and input power monitoring.
Allows enabling or disabling key beep and buzzer sounds for user feedback.
Details setting charge current, voltage, and confirming cell count for Lithium battery charging.
Explains charging in balance mode to equalize individual cell voltages.
Illustrates pin assignments for connecting Lithium battery packs for balancing.
Describes the 'FAST CHG' mode which reduces charging time by modifying CV process.
Shows the current state of the 'FAST' charging process.
Explains mode to charge/discharge batteries to specific voltages for long-term storage.
Displays the current state of the 'STORAGE' charging or discharging process.
Details setting discharge current and final voltage for Lithium batteries.
Explains monitoring and normalizing cell voltages during discharge or storage mode.
Describes error messages for low/high cell voltage and connection issues during monitoring.
Covers charging NiMH/NiCd batteries in 'Aut' or 'Man' mode, including current limits.
Details setting discharge current and final voltage for NiCd/NiMH batteries.
Explains using cyclic charge/discharge for balancing, refreshing, or break-in.
Shows results of charged/discharged capacities after each cycle.
Guides on setting charge current and voltage for lead-acid batteries.
Details setting discharge current and final voltage for lead-acid batteries.
Allows saving up to 5 battery profiles with specifications for quick recall.
Describes setting current, voltage, and cycle numbers for saved battery profiles.
Recalls previously saved battery data to resume charging or discharging.
Displays end voltage, capacity cut-off, safety timer, and USB/Temp status.
Shows individual cell voltages for Lithium battery packs during operation.
Displays the current voltage of the input DC power source.
Lists common warning and error messages and their meanings for troubleshooting.
Defines essential terms like Amps, mAh, Ah, Nominal Voltage, and C-rating.
Provides a chart showing maximum charge/discharge currents based on battery type and cell count.
General| Brand | Bantam |
|---|---|
| Model | e-STATION BC6 |
| Category | Battery Charger |
| Language | English |
