- 18 -
Monitoring the voltage of individual cell using balance guard
Display
Safety Timer
ON 120min
Display
Capacity cut-off
ON 5000mAh
Display
Temp cut-off
ON 80C
The state of safety timer setting up.
The state of temperature cut-off setting up.
The state of capacity cut-off setting up.
Using the external Lithium balancer PB5 or PB6, you can
check the individual voltage of cells in the battery pack.
When connect the communication link cable from the
balancer to the temperature port of the charger the
program shows them for maximum 12 cells. The left
values show the voltages of single cell; the right values
are sum of voltage from the first cell. To utilise this feature,
the battery pack must have the balance tab that linked to
each cells.
This shows the highest voltage and the lowest voltage of
the individual cell.
INC
▶
INC
▶
DEC
◀
DEC
◀
Display
Display
Display
S-1 4.20V 4.20V
S-2 8.35V 4.15V
S11 46.35V 4.20V
S12 50.35V 4.20V
High Vol: 4.20V
Low : 4.15V
To Next Page
Loading...
