3
Main features
• GMRS transceiver • Output power: ≤2W/ ≤0.5W(only 8-14channels)
• 30+8 GMRS channels • Channel monitor
• Channel scan • 260 Privacy Codes (50 CTCSS Codes & 210 DCS codes)
• Vocal tuning • Battery save
• Battery low alert • TOT (Time out timer)
• 2Pin Kenwood accessory jack • Micro USB connector for charging
• Li-Ion 1500mAh battery pack • Up to 5 km range*
• 10 NOAA Weather Channels • NOAA Weather Scan
• Battery Life: up to 18 hours (under typical use conditions)
Note: *Range may vary depending on environmental and/or topographical conditions.
Installation of Accessories
1. Installing/ Removing the Antenna
a. Installing the Antenna: Screw the antenna into the connector on the top of the transceiver by holding the antenna at its
base and turning it clockwise until secure.
b. Removing the Antenna: Turn the antenna counter-clockwise to remove it.
2. Installing the battery pack
Before attaching or removing the battery make sure your radio is turned off by turning the power/volume knob all the way
counter-clockwise.
a. Make sure the battery is aligned in parallel with the radio body with the lower edge of the battery about 1-2cm below the
edge of the radio.
b. Once aligned with the guide-rails, slide the battery upward until you hear a click as the battery locks in place.
To Next Page
Loading...
