4
Remove the battery pack
To remove the battery, press the battery release above the battery pack, as you slide the battery downward.
3. Installing the Belt Clip
To install the Belt Clip, slide the clip down into the slot on the back of the radio until the Belt Clip-latch clicks. To remove the
Belt Clip, press the Lock-tab down, and then gently pull the belt clip up toward the top of the radio.
4. External Speaker/Microphone Jack
Each radio can be used with an optional external speaker/microphone or headset, freeing your hands for other tasks. To use
an optional speaker / microphone or headset:
a. Open the rubber cap on the side of the radio.
b. Insert the plug(s) into the SPK/MIC jacks.
c. Place the ear bud into your ear, and adjust the Microphone into your desired position.
5. Using a Headset
You can use a headset (#480_5R) for more private communications. To use a headset, lift the rubber cover from over the
headset jack, and then plug in the headset.
Important: Your radio is not submersible or waterproof when using a headset jack. When you remove the headset, be sure
to fully press the jack cover into place to restore its waterproof capability.
Charging the Battery
1. Using the Charging Cradle
(1) Connect the USB port of the attached USB charger to the USB output port, such as a power bank or mobile phone
adapter.
(2) Put the charging stand on the table, and place the radio or spare lithium battery in the charging stand.
To Next Page
Loading...
