Baofeng UV3R - Additional Functions and Settings

ADDITIONAL FUNCTIONS AND SETTINGS
MEMORY CHANNEL STORAGE (Memory Channels 01-99)
Store the Memory Channel according to the following instructions:
@Select the desired frequency while operating in the VFO mode. Be sure to
set up any desired CTCSS or DCS tones, as well as any repeater offset.
@Press [F/A] button, then press [U/V] key, Channel 01-99 will
flash on the LCD, rotate [ DIAL ] knob to store the channel between
channel 01-99.
@Press [ U/V] key to save the setting.
@Repeat the process above, to store other channels.
(Note: Repeater offset frequency should be set via programming software.)
EMERGENCY ALARM FEATURE
Press and hold the [ F/A ] button about 1/2 seconds, come to the Emergency
Alarm Mode, emergency alarm will be heard, press [ PTT ] button, EXIT to normal
operation .
FM RADIO FUNCTION
1)Press and hold the button [ L/R ] , come to the FM Radio Mode.
2)Rotate the [ DIAL ] knob to adjust the frequency. (The FM broadcast
coverage is 87.0MHz to 108.0MHz, Frequency step as 100KHz).
3)Then press and hold the [ L/R ] button, EXIT the FM Radio Mode.
21
In the FM radio mode, the communication between the transceivers
is priority. That means in the FM radio mode, when the signal come,
the transceiver will automatically exit the FM radio mode.
FM RADIO SCANNING
In the FM Radio mode, press [F/A] button, then press
{ MENU/LOCK] key to scan the complete band. Clockwise or
counterclockwise rotation of { DIAL] knob to scan the band from low
to high or from high to low. When searches the certain channel, the
scanning will stop at the channel. Rotate the [ DIAL ] knob, continuously
to scan from low to high or from high to low. Press any key to exit the scanning.
22