TROUBLESHOOTING
If you experience a problem with your Baracuda Ranger, please review
the installation section and ensure all steps have been followed correctly.
PROBLEM SOLUTION
1. Machine does not move, or moves sluggishly. • Ensure ideal flow is being attained using pool pulse.
Note: In water 60
0
F or less, it may be necessary to
increase flow to compensate for the reduced flexibility
of the hose and diaphragm.
• Check diaphragm for damage or wear
(see Care and Maintenance).
• Backwash filter and empty pump basket.
• Check for air in system. If water level in pump
basket drops, check hose connections, tighten
all fittings at pump, check gasket in pump
basket for wear.
2. Machine does not cover entire pool. • Ensure ideal flow is being attained using pool pulse.
• Point return jets as far down as possible.
• Make sure hose does not have memory from
being coiled (see Care and Maintenance).
• Confirm proper hose length
• Confirm proper positioning of hose deflectors.
3. Machine sticks on ladder. • Ensure ideal flow is being attained using pool pulse.
• Remove ladder if possible
• Install large wheel deflector
4. Machine sticks in steps. • Ensure correct amount of hose is being used
(see Assembly). Shorten if neccessary.
• Reduce flow to low side of ideal range.
• Install large wheel deflector
5. Machine stays on walls or edge of pool. • Reduce flow to low side of ideal range.
• Confirm proper positioning of hose deflectors.
If further assistance is required, please call 1-888-786-7797.
In Canada, call 1-888-647-4004
11
To Next Page
Loading...
