61780 0221
Barber SURF RAKE
®
Model 600HD
Maintenance & Lubrication Schedule
Every 8 Hours or Every Day:
· Wash Machine After Use
Every 40 Hours or Every Week: Lubricate the following:
Chart Ref. # Barber Part # Description (Quantity)
1 549AS08 8” Roller Assemblies (4)
17 503JJ Main Shaft Bearings (2)
3 503VV Upper Shaft Bearings (2)
22 549AS10A 3 ½” Roller Assembly Bearings (4)
27 549AS20 3 ¼” Roller Assembly Bearings (2)
2 527GF-4 Wheel Bearings (2)
18 545JJF Large Cylinder Fittings (4)
19 545JJH Small Cylinder Fittings (4)
15 A523HD Dump Sprocket Fittings (4)
14 508RG Top Lift Arm Sleeve Bearing Fitting (2)
508RA Caster Arm Sleeve Bearings (2) (Optional Equipment)
Every 40 Hours or Every Week Inspect and/or Adjust:
Chart Ref. # Barber Part # Description (Quantity)
24
504F-1 or
504FH
Replace Damaged Tines / Clear Obstructions on tines
20 A504 Inspect Conveyor Belt Tension (Both Sides)
21 540G Adjust Conveyor Belt Tension If Needed (Both Sides)
6 527KC-1 Inspect and Adjust Tire Pressure 18 PSI (2)
23 525ZP Inspect and Adjust Bucket Chain Assemblies if Necessary
Every 200 Hours or Every 2 Months:
Chart Ref. # Barber Part # Description (Quantity)
504G Check / Torque End Bolts on Conveyor to 40psi (56)
4 522JT1 Spot Lubricate Moldboard Turnbuckle Pins (4)
13 545MM Clean Breather / Filter on Hydraulic Tank
11 545C Change Hydraulic Filter
9 503MMC Inspect and Adjust, if necessary, Main Shaft Drive Chain
10 645 Check Hydraulic Tank Fluid Level
26 542DA Push flap down so it touches chain
Every 500 Hours or Once a Year:
Chart Ref. # Barber Part # Description (Quantity)
7 527GF-4 Adjust / Repack / Replace (if needed) Wheel Bearings
12 645HM Clean Hydraulic Tank Strainer
8 522JT Clean and Grease Moldboard Turnbuckle Assembly (2)
25
549AS10A
549AS08 549AS20
Inspect and Reshim Conveyor Rollers, If Necessary (10)
Every 1000 Hours or Once Every 3 Years:
Chart Ref. # Barber Part # Description (Quantity)
5 645HYOIL Change Hydraulic Fluid 13 Gal (ISO-32 Grade or Equivalent)
To Next Page
