R5900114 /01 ClickShare CX-20 Gen236
Image 2–49
With a Button
Click the Button and unplug the Button from your laptop.
2.14 Audio configuration
Audio configuration
The connected user must control his own audio signal using the audio configuration of his computer. If he
does not want to broadcast his audio signal, he has to mute audio on his computer.
For some operating system, it is necessary to set ClickShare as your default output device. Once you unplug
the Button, the default setting is switched back to the previous setting. The speakerphone selection is also
selected.
Audio configuration
The following configuration is the expected configuration for the playback devices when plugging the Button.
ClickShare speaker as default device and room speakerphone as default communications device.
The speakerphone is available and can be used even when not on screen. The sound coming out of the
speaker is only heard when sharing content. With this defaults, the content audio will be played by the
speakers and communication clients (UC&C and conferencing tools) will use the room speakerphone. For
best experience, the room speakerphone should be selected in the communications client at all times.
Difference is that the audio from the Speakers will be lip-synced with the content, but will have higher latency.
The communications device is optimized for the lowest latency possible, but no lip-sync is guaranteed with the
video. For an optimal conference, the audio should always be transferred with lowest latency possible and will
get priority over video.
Getting started
To Next Page
Loading...
Need help?
General
