3. Display installation
Image 3-2
CAUTION: Do not try to pivot your display when attached to the stand. Trying to do so
could cause serious damage to your display and its stand.
3.3 R emoving t he cover
To remove the connector compartment cover
The connector compartment cover should be removed to get access to the connectors. To remove the
cover, gently slide the connector compartment cover upwards and remove it from the display.
Image 3-3
3.4 Co nnecting the cables
To connect the cables
1. Connect one or more of the video input connections of your display (VGA, HDMI or DisplayPort) to the
corresponding video outputs on your computer or any other video device.
2. If you want to make use of the
display’s USB downstream connectors, then connect your workstation
with the display’s USB upstream connector by means of the supplied USB cable.
3. Connect a speaker, amplifier, ... with the display’s audio line out if you want to use the internal sound
option of your display.
8
K5903049 EONIS 19/02/2014
To Next Page
Loading...
Need help?
General