Barco UDM W30 - Use Case 3: Neutrik Opticalcon Quad + SFP+ Transceiver + Internal Fiber

R5911438 /09 UDM84
7.3 Use case 3: Neutrik OpticalCon Quad + SFP+
transceiver + internal fiber
Neutrik OpticalCon Quad + SFP+ transceiver + internal fiber
1
5
32
4
Image 7–3
1 SFP input board
2 Neutrik OpitcalCon Quad
3 Internal fiber cable
4 SFP+ fiber transceiver
5 Advanced quad cable
Barco delivers only the SFP input and SFP+ fiber transceivers. The customer has to buy the SFP+
transceiver and the optional breakout adapter or the fiber integrated cable.
How to configure the SFP input
1. Remove one plate covering the access to a Neutrik connector location.
2. Mount the Neutrik OpticalCon Quad connector.
3. Remove the plate covering the access to the SFP cage and insert the SFP+ transceivers.
4. Re-install the cover plate.
5. Mount the optical internal cables between the Neutrik connector and the SFP+ transceivers.
6. Install the SFP input in its slot of the Input & Communication module. See procedure “Installation of an
input board”, page 55.
Pulse SFP input use cases