R5906112 /09 UDX series148
9.1 Saving the current projector settings in a
profile
Which settings can be saved to a profile?
Profile setting
name
Settings saved
Source Active source selection
Image • All basic image settings: contrast, brightness, saturations, sharpness & gamma
• Used gamma type
• Digital Zoom (width / height / factor)
• Digital shift (x/y)
• Output resolution
PQ Screen luminance & HDR boost value
P7 Realcolor Color mode & coordinates
Installation • Lens parameters (lens zoom, focus & shift)
• Position of motorized frame (if used).
• Shutter status (open or closed).
• Orientation (mounting & projection)
• Scaling mode
Warp • Warp status enabled / disabled
• Screen size
• Warp file selected
• Transport Delay
Note: Bow and 4Corners warp cannot be saved.
Blend • Blend mask enabled / disabled
• All Masks (top / bottom / left / right) and heights (top / bottom / left / right)
• Blend files enabled / disabled
• Blend file selected
Black level • Black level file enabled / disabled
• Black Level file selected
• Basic black level enabled / disabled
• Black level settings (top / bottom / left / right)
RGB Adjustment Red, Green and Blue values
Illumination • Power setting
• CLO enabled / disabled
• CLO set point
Cooling
7
Selected Cooling mode
3D setup • Display mode used
• Swap eyes on / off
• Swap frame pair on / off
• Dark time and sync delay values
How to save the current projector profile to a macro?
1. In the main menu, select Profiles → New.
GUI – Macro’s and projector profiles
7: Only if external cooler is installed
To Next Page
Loading...
