Bard Site-Rite 5 User Manual (English)

Other manuals for Bard Site-Rite 5

Questions and Answers:

C
Charles MeadowsAug 6, 2025
How to fix Bard Diagnostic Equipment when it will not power on?
- C
  Cassandra ChenAug 7, 2025
  If your Bard Diagnostic Equipment system doesn't power on, and the power LED isn't lit, the fan isn't running, and there's no display, first, ensure you press the power button for at least one second. If that doesn't work, plug the unit into a working outlet to charge the battery, as it may be discharged. Also, check the AC adapter by plugging the unit into a known working outlet and verifying the power LED on the scanner assembly is blinking. If it's not, measure voltage levels on the DIN connector; the DIN Shield is GND, and pins 1 & 3 should read approximately 15VDC.
A
Amy SmithAug 12, 2025
What to do if Bard Diagnostic Equipment scanner assembly powers on momentarily then shuts off?
- K
  Kelly BaileyAug 12, 2025
  If your Bard Diagnostic Equipment scanner assembly powers on briefly and then shuts off, the battery may be discharged. Try plugging the unit into a working AC outlet to operate the system and charge the battery.
D
dillonjoshuaAug 18, 2025
Why gain up and gain down buttons on Bard Diagnostic Equipment scanner or probe do not work?
- K
  Kimberly VillegasAug 18, 2025
  If the gain up and gain down buttons on your Bard Diagnostic Equipment scanner or probe aren't working, it could be because the system is in freeze mode. Press the freeze button to exit this mode. If that doesn't solve the problem, the button pad might be defective, and you should use replacement scanner buttons until the unit can be serviced.
D
Dawn GomezAug 25, 2025
What to do if depth buttons on Bard Diagnostic Equipment scanner or probe do not work?
- C
  Carol TurnerAug 26, 2025
  If the depth buttons on your Bard Diagnostic Equipment scanner or probe are not working, the system might be in freeze mode. Press the freeze button to take it out of freeze mode. If the buttons still don't respond, the button pad could be defective. In this case, use replacement scanner buttons until the unit can be serviced.
K
Kirk LunaAug 30, 2025
How to improve poor image on Bard Diagnostic Equipment?
- M
  Michael RyanAug 30, 2025
  If the image quality is poor or penetration is inadequate with your Bard Diagnostic Equipment, try using more coupling gel. Also, check the sheath on the acoustic window of the probe for any folds or seams, and smooth it out.