Manual 2100-604A
Page 28 of 28
TABLE 10
Vent and Control Options
W18, W24
W30, W36
W42, W48, W60
Part Number Description
CMC-14 ODT X X X
CMC-15
Start Kit (230V 1-Phase only)
X X X
SK111
Start Kit (230V 1-Phase only)
X X X
CMC-28 LAC X X X
BFAD-2 Barometric Fresh Air Damper - Standard X
BOP-2 Blank Off Plate X
MFAD-2 Motorized Fresh Air Damper X
CRV-2 Commercial Ventilator - Spring Return X
ECONWMS-E2B Economizer X
ERVF-A2 Energy Recovery Ventilator - 230 Volt X
BFAD-3 Barometric Fresh Air Damper - Standard X
BOP-3 Blank Off Plate X
MFAD-3 Motorized Fresh Air Damper X
CRVS-3 Commercial Ventilator - Spring Return X
CRVP-3 Commercial Ventilator - Power Return X
ECONWMS-E3B Economizer X
ERVF-A3 Energy Recovery Ventilator - 230 Volt X
ERVF-C3 Energy Recovery Ventilator - 460 Volt X
BFAD-5 Barometric Fresh Air Damper - Standard X
BOP-5 Blank Off Plate X
MFAD-5 Motorized Fresh Air Damper X
CRVS-5 Commercial Ventilator - Spring Return X
CRVP-5 Commercial Ventilator - Power Return X
ECONWMS-E5B Economizer X
ERVF-A5 Energy Recovery Ventilator - 230 Volt X
ERVF-C5 Energy Recovery Ventilator - 460 Volt X
PTCR Start Kit can be used with all -A single phase models. Increases starting torque 2-3x. Not used for -B or -C three phase
models. Do not use if SK111 is used.
Start Capacitor and potential relay start kit can be used with all -A single phase models. Increases starting torque 9x. Not used
for -B or -C three phase models. Do not use if CMC-15 is used.
To Previous Page
Loading...
