1324D-1624D Owner’s Manual 8/29/18 Page 11 of 19
SPEED CABLE ADJUSTMENT
ADJUST HERE
Speed cables should be adjusted so trencher is stationary when clutch lever is pulled up and speed
lever is in neutral.
Speed cables should be adjusted if trencher creeps when in neutral. Adjust the cables to bring the
pump cable arms to the neutral position (vertical) when the wheel control levers are in neutral. Adjust
the cables to eliminate slack, but do not over tighten them so they are extremely tight against each
other.
Loosen locknuts and adjust as needed. Adjustment may be made at both ends of cable housing.
To Next Page
