FA-(B)W – EN 5
3. SAFETY!
Follow all safety-rules including the instructions in the manual and the safety labels on the
machine.
Because this machine is used in combination with the tractor, also read the operator’s manual
of the tractor.
The installed safety-equipment like:
- protection cover PTO shaft and planting elements page 7-9-28-29
- protection rails on both sides and 4 support legs page 7-28-29
- safety labels explained and position on the machine page 8-9
should under no circumstances be removed and should in case of damage be repaired
or replaced immediately.
The protection of the PTO shafts should be secured with small chains to the protection covers
to prevent them from turning.
Ensure proper protection of the clutch shafts. Replace protections by damages directly.
Never carry out repairs or adjustments or leave the tractor unless gear lever is in neutral,
brakes on, and engine switched off with ignition key removed.
The machine should be in lowest position on the ground on 4 support legs and firmly
supported.
Always use a tractor with a cab.
Consult the manual of the tractor with respect to coupling and safe operation.
Declutch and shift into neutral before starting the engine of the tractor.
Through the high speed of the PTO shaft and rotor shaft, and non-compliance or
enforcement of safety rules the machine can be a dangerous machine.
NEVER LIFT THE MACHINE WHEN THE ROTOR SHAFT IS RUNNING!
Follow this procedure: 1) switch off PTO shaft tractor
2) wait until the rotor shaft completely stopped turning
3) lift the machine with the 3 point linkage
This machine should only be operated by experienced and careful persons who know
the machine, who have read the manual and therefore know the instructions and safety-
rules.
By transport on public roads, take care of the local and general regulations like: lightning,
reflectors, length and width of warning signs.
By transport on public roads or while working in the land there should be no persons or loose
parts on the machine.
To Next Page
Loading...