EasyManuals Logo

Basler DGC-2020ES Instruction Manual

Basler DGC-2020ES
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
40 9469200994 Rev
Revision History DGC-2020ES
Firmware
Version and Date
Change
Changed to prevent Oil Pressure Crank Disconnect from operating if
there is a valid RPM Source
Removed the letter "DPF" from DPF Regenerate Required and DPF
Regeneration Inhibited Strings
Added Selective Catalytic Reduction Parameters to the list of strings
displayed for SPN's in Diagnostic Trouble Codes
Modified front panel so that if MTU Fault Codes are in effect while an
alarm or pre-alarm is in effect, the DGC-2020ES will alternate
between the Alarm or Pre-alarm display and the MTU Fault Code
display
Added a Mains Fail Transfer Status screen on the front panel
Changed to prevent unit from starting the machine when Battle
Override is engaged after an alarm occurs, but the OFF button has
never been pressed to clear the alarm, if the DGC pulses while in the
alarm state, at the end of the pulse cycle
Generator Status string now displays Alarm if Battle Override is
applied after an alarm shutdown
1.01.01, Apr-14
Made the J1939 data menu available through the HMI when the unit
is configured for Scania ECU type
1.02.00, Oct-14
Added MTU Speed Demand Switch setting from logic capability
Added a rest timer for cyclic cranking
Added Mains Fail Return Fail pre-alarm and Mains Fail Max Return
Time setting
Added John Deere to list of ECU configurations
Changed DEF EMPTY pre-alarm to DEF LOW SEVERE
Changed DEF ENGINE DERATE pre-alarm to DEF INDUCEMENT
Added descriptive text for Diagnostic Trouble Codes (DTC’s)
broadcast by Mercedes, PSI, and MTU-ECU9 engine ECU’s
Added ECU9 Fault Code list for MTU
1.03.00, May-16
Added Cylinder Cutout Enable Override logic element
Added a setting for Expected Engine ECU Address
Added a setting for CAN Bus Low Coolant Level Alarm Enable
Changed to set Expected Engine ECU Address to 0 when ECU
CONFIG is GM/DOOSAN.
Added Chinese language support
Modified checksum handling to prevent a false Checksum Fail pre-
alarm
Changed alarm annunciation so alarms are not suppressed if the
OFF mode logic element is held true and prevents unit start attempt
if the OFF mode logic element is held true and an alarm is active
Improved J1939 transmit buffer handling
Changed how the DGC-2020ES sends an Acknowledgement PGN
indicating No Acknowledgement (NACK) when a request PGN is
received that had the Global Address as the Destination Address
Improved ac line-to-line voltage calculation to allow for hardware
gain differences between voltage channel inputs
Table 18. Software Revision History
Software
Version and Date
Change
3.03.00, Mar-13
Initial Release
3.03.03, Jun-13
Maintenance release (BE1-11 changes)
3.04.00, Aug-13
Maintenance release (BE1-11 changes)

Table of Contents

Other manuals for Basler DGC-2020ES

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Basler DGC-2020ES and is the answer not in the manual?

Basler DGC-2020ES Specifications

General IconGeneral
BrandBasler
ModelDGC-2020ES
CategoryController
LanguageEnglish

Related product manuals