Bauer 20106E-B - Component Replacement; Sanding Belt Replacement; Drive Belt Replacement;Tensioning

Page 12 ;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1 Item 58339
EF;6GH IJ6KFGLIM NFLMG6MFMO6E6GPJ
E,89"83%S*7$%K*/7,4*5*8$
1. Loosen the Belt Support Locking Screw.
Raise the Belt Support Assembly to 45°
and tighten the Locking Screw.
2. Pull the Belt Tension Lever out to release
tension on the Sanding Belt.
3. Slide the old Sanding Belt off the
front and rear Drums.
4. 6OLGHDQHZ௘[௘6DQGLQJ%HOWRQWRWKH
front and rear Drums with the directional
arrows on the inside of the Belt pointing in the
direction of rotation as indicated on the tool.
5. Center the Belt correctly on both Drums.
Push the Tension Lever back to tighten
the Belt to the Belt Support Assembly.
6. Loosen the Belt Support Locking Screw,
lower the Belt Support to its horizontal
position and tighten the Locking Screw.
7. Before using, check the new Sanding
Belt for alignment. Refer to Adjusting
Sanding Belt Tracking on page 8.
;"3'(*%a
E,89"83%
S*7$
S*7$%
E'//&($%
F##*5+7V%
T&4b"83%
E4(*)
U('5
U('5
'ULYH%HOW5HSODFHPHQW௘௘7HQVLRQLQJ
1. /RRVHQWKH0௘[௘6FUHZVHFXULQJ
the Drive Belt Housing Cover (67). Lift the
Cover up over the screw and remove it.
2. Once the Cover is removed, the
Drive Belt (70) is accessible.
3. Loosen the three Phillips-head screws securing
the Drive Belt Housing to the Sander body.
4. Loosen the Tensioning Screw at the bottom of the
Drive Belt Housing by turning counterclockwise
to release tension on the Drive Belt.
5. Remove the old Drive Belt. Place the new Drive
Belt onto the Pulleys, making sure the Belt is
properly seated in the grooves of both Pulleys.
6. Tighten the Drive Belt by turning the
Tensioning Screw at the bottom of the
Drive Belt Housing clockwise.
7. Tighten the three Phillips-head screws
securing the Drive Belt Housing.
8. Check Drive Belt tension by squeezing both sides
of the Belt toward each other. When properly
adjusted, the Belt should deflect anywhere from
1/8 to 1/4 inch. Make sure the Belt is properly
seated in the grooves of both Pulleys.
9. Replace the Drive Belt Housing Cover
and tighten the Screw securely.
U("W*%S*7$%
]&'#"83%
O&W*(
E4(*)
U("W*%S*7$%
]&'#"83
U("W*%S*7$
J."77"/#%J."77"/#%
E4(*)E4(*)
J."77"/#%J."77"/#%
E4(*)E4(*)
G*8#"&8"83%
E4(*)%
;"3'(*%^