Bauer 20106E-B - Troubleshooting; Common Problems and Solutions

Page 13;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1Item 58339
EF;6GHIJ6KFGLIMNFLMG6MFMO6 E6GPJ
G(&'+7*#.&&$"83
J(&+7*5 J&##"+7*%O,'#*# T"b*7V%E&7'$"&8#
Belt/Disc Sander
does not turn on
1. Not plugged in.
2. No power at outlet.
3. Safety Key not inserted into Switch.
4. Switch is not turned ON.
1. Plug in Sander.
2. Check power at outlet and/or circuit breaker.
3. Insert Safety Key into Switch.
4. Turn on the Switch.
Motor slows
when sanding
1. Drive Belt too tight.
2. Applying too much pressure
while sanding.
1. Have the Drive Belt adjusted by
a qualified technician.
2. Use less pressure.
Wood burns
while sanding
1. Sanding Disc or Belt may be
loaded with dirt or debris.
2. Applying too much pressure
while sanding.
1. Clean or replace Disc or Belt using
instructions in this manual.
2. Use less pressure.
% ;&77&)%,77%#,2*$V%/(*4,'$"&8#%).*8*W*(%9",38&#"83%&(%#*(W"4"83%
$.*%$&&71%%U"#4&88*4$%/&)*(%#'//7V%+*2&(*%#*(W"4*1