Page 6 For technical questions, please call 1-888-866-5797. Item 59583
SAFETY OPERATION MAINTENANCESETUP
Specifications
Electrical Rating 120VAC / 60Hz / 6A
Spindle Speeds 60 - 3550 RPM
Spindle Thread Size 1″ x 8 TPI
Swing Over Bed 14″
Swing Over Tool Rest 10-1/2″
Distance Between Centers 20″ Maximum
Tailstock Taper MT2
Tailstock Quill Travel 3.5″
Number Of Indexing Positions 24
Weight 105 lbs
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off, remove the Safety Key, and unplug the tool
from its electrical outlet before performing any procedure in this section.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Assembly/Mounting
1. Screw 4 Rubber Feet (1) into the holes located
at each corner of the tool. Make sure that
tool sits evenly on the feet when finished.
2. Insert Power Cord (86) into outlet
on the Control Box (200).
Installing Storage Brackets:
1. Using a screwdriver (not included), attach
Storage Bracket (16) to the side of the lathe
using 2 Washers (15) and 2 Screws (14).
2. Repeat the process on the other side
to install the second Bracket.
To Next Page
Loading...